AAC SAW
The diamond-tipped saw is designed for precise and easy cutting of KCS Kipas Gazbeton products.
CUTTING SQUARE
Used for symmetrical cutting of AAC blocks.
AAC SURFACE RASP
Used to correct small edge defects that occur while laying or cutting AAC blocks.
AAC SCOOP
AAC notched scoops are selected according to product thickness when building AAC walls.
AAC TROWEL
Trowels are specially produced to apply adhesive quickly and in sufficient amounts while building KCS Kipas Gazbeton walls.
DRIVE-IN DOWEL
A dowel mounted to the building's structural element for special KCS Gazbeton blocks developed for earthquake safety.
INSTALLATION CHANNEL OPENER
Enables easy opening of channels required for electrical and mechanical installation pipes in AAC walls.
ELECTRICAL BOX OPENER
This product, used with a drill, is used to open electrical junction box channels properly.
ADHESIVE MIXING PADDLE
A mixing paddle that enables AAC masonry mortar to be mixed easily and quickly with water.
RUBBER ALIGNMENT MALLET
Used to create alignment during AAC block laying and to ensure adhesive continuity between two blocks.
C-TYPE ANCHOR RAIL
Stainless equipment used to mount AAC building elements to the building's structural system.
V-TYPE PULLING NAIL
An angle-shaped nail used to fix panel pulling equipment to AAC.
PANEL PULLING EQUIPMENT
Equipment used in reinforced AAC product installation and connected to anchors with V nails.
ANGLED PANEL PULLING ELEMENT
Angled equipment used in reinforced AAC product installation and connected to anchors with V nails.
PALLET LIFTING AND LOWERING EQUIPMENT
Equipment used to unload AAC products from vehicles without damage and stack them on building floors.
VERTICAL AND HORIZONTAL WALL LIFTING INSTALLATION EQUIPMENT
A type of equipment that grips KCS Kipas Gazbeton wall panels from the crane end during building installation and prevents them from falling.
ROOF AND FLOOR INSTALLATION ELEMENTS
Used as horizontal holders when installing AAC floor and roof panels on buildings.